AUDIOLINE Baby Care 12 eco zero, Руководство по эксплуатации

Страница: 20 / 28

6
Operation
4 Operation
Once you have set up your baby monitor, you will be able to hear the sounds in your baby´s room
through the parent unit. You will also be able to see those sounds as the sound sensor lights on the
parent unit, which rise and fall with the volume level.
a
Note: If the connection between the parent unit and baby unit is broken at any time the green
“Link“ light on the parent unit will flash and you will hear short beeps. To re − establish the “Link“, follow
the directions in the “Troubleshooting“ chapter.
Powering on/off the baby monitor
After having connected the baby monitor you will have to switch on both units.
Press and hold down the On/Off key on each unit.
To switch off the unit press and hold down the On/Off key again.
Volume
You can adjust the volume at which you hear your baby by using the keys ▲ and ▼ on the parent unit.
Using the volume keys +/- on the baby unit you can adjust the volume for your voice (when speaking
from the parent unit) and the lullabies (only for the internal source). If a MP3 player is connected to the
baby unit, the volume is adjusted by the MP3 player volume keys.
Battery charge indicator and battery low warning
The parent unit will work up to 8 hours without charging, but this depends on the amount of activity and
the level of the charge in the batteries. On the display you can see the charging status:
Battery icon full
= full capacity
Battery icon 1/2 full = approx.half capacity
Battery icon empty / battery symbol flashes = batteries must be charged
Sound alert
You can set your parent unit to give an extra warning “beep“ should the noise levels in your baby’s
room activate the light on the sound sensor. This is particularly useful if the volume of your parent unit
is turned down and you are just using the sensor light to monitor the noise levels in your baby’s room.
Baby unit to parent unit paging
Useful if one parent is in the baby’s room and needs to contact the other. Also helps to find a mislaid
parent unit.
At the baby unit
Press and hold the Page Key briefly. The parent unit will emit a tone. The tone can be switched off by
pressing any key on the parent unit or by pressing the Page key on the baby unit once again.
Display of the temperature and humidity in the baby’s room
Press and hold down the OK/Menu key for approx. 2 seconds.
The temperature and humidity in the baby’s room will be displayed. The information will be updated
once in a minute.
Press and hold down the OK/Menu key for approx. 2 seconds to return to the date/time display.
Baby Care 12 eco zero_GB_210x148mm_V1-1_4 250711 991265_040313_Serie_XP9_DTP direkt KG 04.03.13 13:04 Seite 6