Audiolab LIVE 24 XL, Руководство пользователя

Страница: 21 / 66

P. 21
- AUDIOLAB Live 24 XL
Adjust this parameter to change selected
output channel audio. This fader function is
the same with Parameter Adjust knob, they
will change synchronously.
Touch pan left or right to change signal’s
balance effect, it can be adjusted by Pa -
rameter Adjust knob on the panel when
pan button is on. If you have adjusted a
channel pan, please just touch 2 times on
the screen and make it back to the centre
position.
Touch anyone of these controls to enter corre-
sponding page.
Touch it, the background and Link but-
ton will illuminate synchronously, and
current channel will link to its default
paired-channel, the button will illuminate then.
Touch Select icon here, all input chan-
nels will display to you. Please follow
the indication on the LCD screen to operate. For
different input channels, the function and output
assignments are different, please notice indication
on the screen. When switch to AUX 5-8, enables
output assignments to be more.
Channel interface
Touch it in Polarity to invert the phase
of the selected channel's signal (to
alter the phase by 180°). If the phase
reverse is active the button will illuminate. The
LCD display shows the phase reverse setting in
real time. The Polarity control can be used to
correct audio signals which are out of phase as
well as to cancel/reinforce each other.
Touch it in Delay Time can engage
and disengage the delay for the se-
lected channel. It will illuminate to indicate that
the delay has been pressed and enabled. The
LCD display shows the delay time in real time. It
can be set 300ms at 48K Hz. Please notice that
only if the Delay button has been enabled can its
parameter be adjusted.
When Delay icon is engaged, touch it
in Delay Time and rotate the Param-
eter Adjust knob can control the selected chan-
nel’s delay time.
Touch it, the function is the same as
Link button on the panel.
Touch this control, it will illuminate as
well as the button, signal from a se-
lected channel can be assigned to Main channel,
for the details please refer to assign introduction
in section "Assign interface".
Touch the switch ON to enable Gate
function, then rotate Parameter
Adjust knob or slide long fader on the
LCD screen to adjust value of Thresh-
old, which will show in the middle
box. During adjustment, correspond-
ing figure change will show in the
Gate grid. In this area, you can touch
the grid area to enter Gate page, for
the detail of Gate function, please refer to the
Gate introduction in section "Gate interface".
Touch the switch ON to enable EQ function, it
English version