AudioControl SAVOY, Руководство по установке

Страница: 12 / 22

Savoy
tm
O P E R AT O R’ S
M A N U A L
If you elect to draw power from a switched outlet in your system, you
will need to verify that the Savoy can handle the power rating. Also,
please do not cut off the ground pin on the power connector. If you
need to plug it into a two-prong outlet, use a correctly installed ground
adapter.
Physical Installation
For your Savoy amplifier to operate properly, it needs to be installed cor-
rectly. To do so, you will need the following:
1. Savoy amplifier.
2. Source unit (most commonly a surround processor or pre-amp, such
as the AudioControl Maestro or Maestro M2).
3. Audio cables to carry the signal from the source unit to the Savoy am-
plifier (Either RCA or XLR).
4. Speaker wire to carry the power from the Savoy amplifier to the
speakers.
5. Rack mounts (when mounting the Savoy in an equipment rack)
– Sold Seperately.
6. Ears to enjoy the pristine sonics the Savoy amplifier will produce!
Remote Power Control
The Savoy amplifier has three levels of power control:
1. Main AC Power Switch: This is the master power control for the Savoy,
located on the rear panel. It must be switched ON for the amplifier to
function. The Remote Power Control will only power the amplifier on
if the Main AC Power Switch is set to ON. It is also wise to wait until
installation is complete before supplying power.
2. Remote Power Control: This removable
1 ⁄
8
” mono jack connector
serves as the interface between any external control and the Savoy
amplifier. If you are not using an external control you DO NOT need
to connect power to this plug. See Figure 2.
3. Front Panel Standby Button: The Standby button toggles the Savoy
amplifier in and out of standby mode. When the Savoy is in standby
mode, the light in the button will illuminate. While in standby, no
signal is being sent from the amplifier to the speakers (though there is
still power to the Savoy amplifier).
page 6
Figure 2. 1 ⁄
8
”
mono jack