12
Rear Panel
10 . AC Input – Connect the supplied AC
power cord securely to this input. Plug
the other end into an AC mains outlet
of the correct voltage rating for your
unit. They are either 100 -120 VAC (50
– 60 Hz) or 220 – 240 VAC (50 – 60 Hz);
look at the check box to see how your
unit has been configured. The voltage
setting is not user-settable. This unit
is a class 1 device, so it is recommend-
ed that you do not defeat the safety
ground connection or use a power cord
that does not have the safety ground
pin.
The Pantages G4 draws an average of
263 watts with typical source mate-
rial. Make certain that it is plugged
directly into the wall outlet, or a surge
protector power strip with sufficient
power rating. Since The Pantages G4
has remote power switching using the
trigger system, you can plug the unit
into an outlet that is always active.
11 . AC Fuse – The main power supply fuse
may be checked or replaced.
WARNING: Make sure that the power
cord is unplugged from the AC mains
before checking or replacing the fuse.
Use a flat-headed screwdriver to undo
the fuse carrier from the fuse holder.
Inspect the fuse and replace with the
exact same type indicated on the unit.
The use of any other type of fuse may
lead to an unsafe condition. If the fuse
blows again immediately, then unplug
the power cord and contact our fine
folks in customer service. Do not open
the unit, as there are no user-ser-
viceable parts inside, and dangerous
voltages exist.
