AudioControl Epicenter 1200, Руководство по установке

Страница: 14 / 36

14
Installation Manual
8. The Epicenter amplifier has speaker-level inputs that are de-
signed to accept an amplified, speaker-level signal from a fac-
tory source unit or amplifier. You may need to refer to a factory
service manual or wiring-harness schematic to determine which
wires are the speaker wires for your system. If you are unsure
which are the speaker wires, we recommend you look at the
color of the speaker wires connected to the speakers and fol-
low them back to the source. Connect the speaker wires to the
Epicenter amplifier’s green speaker-level input plug using the
correct polarity. It is critical that the audio output you use is full
frequency range, so the factory rear speaker wires would gener-
ally be the optimum choice. Connecting to the factory subwoof-
er wire is not recommended.
9. Line-level audio signals will generally come from your aftermar-
ket radio, or if you are really getting the most out of your car
audio system they may be coming from a really awesome prod-
uct like the AudioControl DQDX!! (Shameless plug). There are
generally only two things to consider when using the line-level
RCA inputs: 1. Use good shielded or twisted pair RCA cables and
2. Run your RCA cables at least 18” away from power and speaker
cables to avoid picking up radiated noise in your system.
Chapter 4: Installation