A
CTIVE
-B
ALANCED
S
ERIES
®
A
CTIVE
-B
ALANCED
S
ERIES
®
9
16
Troubleshooting
“No Picture or Sound.”
1.Make certain the Power light is on the BVR-25 and the
power is on for the sending unit (i.e. BVD-20 or
BVH-20).
2.Verify that the RJ-45 termination on both ends of the
Cat-5 is correct. We all know this is easy to get wrong.
Use an RJ-45 cable tester to verify.
3.Make certain the Cat-5 cable run does NOT go through
an Ethernet Router or hub. It is alright to run the signal
through a passive patch bay.
4. Make certain display or monitor is compatible with
format of choice, i.e. 480P; 1080i; etc.
“No Power Light.”
1. Confirm that you are using the proper 12 VDC for the
BVR-25 and that the outlet has power.
“Horizontal bars across the screen”
1.Check the power grounding of the display device, the
video processor, satellite dish, cable box, and all com-
ponents in the video signal path. They should all be
grounded back at the electrical panel, not locally.
2.Make sure that the CAT-5 wiring going into your BVR-
25 is not running parallel with any high voltage AC
systems.
“Video picture scrambled or colors incorrect”
1.Confirm that the “Y”, “P
B
”, and “P
R
” connections are
correct.
Power Wiring
The BVR-25 operates with a 110 VAC to 12 volt DC wall
plug transformer (provided) that is terminated with a 5mm
jack that will plug into the front panel. We have conve-
niently labeled this jack “+12VDC Input”. Please note that
the 12 volt supply transformer provided with the BVR-25
is different than the 24 volt supply that is used with some
other AudioControl balanced line products. Therefore, be
careful to not use the wrong power supply. Please note that the
striped wire is positive (+) and the solid wire is negative (-).
Optional Rear Power Connection
As an option you can power the BVR-25 via connection
to a barrier block on the rear panel instead of the 5mm jack
on the front panel which allows for a cleaner trim-out of
System 4: Video signal being fed into BVD-20 and routed to multiple BVR-25’s
via daisy chain wiring
