AudioCodes MediaPack MP-1 Series, Конфигурационная записка

Страница: 9 / 18

Configuration Note 2. Setting Up FXS Lines on MP-1xx
Version 3.0 9 February 2013
2 Setting Up FXS Lines on MP-1xx
Before setting up the FXS lines, you need to create an SPS user in the SPS Web Admin
Tool. Follow the instructions on how to create a new SPS user in the “Adding a User via
the SPS Web Admin” section of
SPS for Lync Quick Start Guide.
To set up FXS lines on the MP-1xx for the SPS, follow the steps described below.
Note: For FXS lines only create an SPS User as there is no need to define a device
for this user.
2.1 Configuring the SPS as a Proxy
The procedure below describes how to configure the SPS as a Proxy.

To configure the SPS as Proxy:
1. Click on Configuration > VoIP > Control Network > Proxy Sets Table ; the Proxy
Sets Table page opens.
Figure 2-1: Proxy Sets Table
2. In the 'Proxy Address' field, insert the IP address of the SPS.
3. Click Submit .
2