AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 406 / 920

User's Manual 406 Document #: LTRT-10437
Mediant 500 E-SBC
3. Configure Q.931 cause codes that invoke alternative IP-to-Tel routing:
a. Open the Reasons for IP-to-Tel Alternative Routing page ( Configuration tab >
VoIP menu > GW and IP to IP > Routing > Alternative Routing Reasons >
Reasons for IP-to-Tel ).
b. Click Add ; the following dialog box appears:
Figure 24-7: IP to Tel Reasons - Reasons for Alternative Routing Page
c. Configure a Q.931 release cause code for alternative routing according to the
parameters described in the table below.
d. Click Submit , and then save ("burn") your settings to flash memory.
Table 24-7: Reasons for IP-to-Tel Alternative Routing Table Parameter Descriptions
Parameter Description
Index
[AltRouteCauseIP2Tel_Index]
Defines an index number for the new table record.
Release Cause
CLI: rel-cause
[AltRouteCauseIP2Tel_ReleaseCause]
Defines a Q.931 release code that if received, the device
attempts to route the call to an alternative destination (if
configured).
24.6.2 Alternative Routing to an IP Destination upon a Busy Trunk
The Forward on Busy Trunk Destination table lets you configure alternative routing rules for
forwarding (i.e., call redirection) IP-to-Tel calls to an alternative IP destination using SIP
3xx responses. These rules are used upon the following:

For digital interfaces: Trunk Group has no free channels (i.e., “busy”).
This feature is configured per Trunk Group. The alternative destination can be defined as a
host name or as a SIP Request-URI user name and host part (i.e., user@host). For
example, the below configuration forwards IP-to-Tel calls to destination user “112” at host
IP address 10.13.4.12, port 5060, using transport protocol TCP, if Trunk Group ID 2 is
unavailable:
ForwardOnBusyTrunkDest 1 = 2, 112@10.13.4.12:5060;transport=tcp;
When configured with user@host, the original destination number is replaced by the user
part.
The device forwards calls using this table only if no alternative IP-to-Tel routing rule has
been configured in the Inbound IP Routing table or alternative routing fails and the
following reason(s) in the SIP Diversion header of 3xx messages exists:

For digital interfaces: “out-of-service” - all trunks are unavailable/disconnected

"unavailable":
•
For digital interfaces: All trunks are busy or unavailable
The following procedure describes how to configure Forward on Busy Trunks in the Web
interface. You can also configure this using the table ini file parameter,
ForwardOnBusyTrunkDest or CLI command, configure voip/gw routing fwd-on-bsy-trk-dst.