AudioCodes Mediant 4000 SBC, Руководство пользователя

Страница: 92 / 1037

CHAPTER 7 CLI-Based Management
Mediant 4000 SBC | User's Manual
> enable
d. At the prompt, type the password again, and then press Enter:
Password: Admin
Viewing Current CLI Sessions
You can view users that are currently logged in to the device's CLI. This applies to users logged in
to the CLI through RS-232 (console), Telnet, or SSH. For each logged-in user, the following is
displayed: the type of interface (console, Telnet, or SSH), username, remote IP address from
where the user logged in, and the duration (days and time) of the session. Each user is displayed
with a unique index (session ID).
➢
To view currently logged-in CLI users:
1. Establish a CLI session with the device.
2. Run the following command:
# show users
[0] console
Admin local 0d00h03m15s
[1] telnet John 10.4.2.1 0d01h03m47s
[2]* ssh Alex 192.168.121.234 12d00h02m34s
The current session from which this show command was run is displayed with an asterisk (*).
The device can display management sessions of up to 24 hours. After this time, the
duration counter is reset.
Terminating a User's CLI Session
You can terminate users that are currently logged in to the device's CLI. This applies to users
logged in to the CLI through RS-232 (console), Telnet, or SSH.
➢
To terminate the CLI session of a specific CLI user:
1. Establish a CLI session with the device.
2. Run the following command:
# clear user <session ID>
Where < session ID > is a unique identification of each currently logged in user. You can view
the session ID by running the show users command (see Viewing Current CLI Sessions ).
The session in which the command is run cannot be terminated.
- 59 -