AudioCodes Mediant
A. Configure PSTN FallBack (if Required)
BroadCloud Hosted UC
41
AudioCodes Mediant CRP
A
Configure PSTN FallBack (if Required)
This section shows how to configure CRP PSTN Fallback.
Note:
Only applies to devices with a PSTN interface, i.e., Mediant 500L/500/800B.
A.1
Step 1: Cabling
A.1.1 Connecting BRI to the Mediant 500L
This section shows how to connect the device's BRI ports to the PBX.
Warning:
To protect against electrical shock and fire, use a 26 AWG min wire.
To connect a BRI line:
1.
Connect the RJ-45 cable to the device's BRI port on the rear panel (it's labeled S2 /
BRI).
2.
Connect the other end of the cable to your ISDN PBX equipment.
Figure
A-1: Cabling BRI Ports
