AudioCodes Mediant 2000, Руководство пользователя

Страница: 34 / 418

SIP User's Manual 34 Document #: LTRT-68808
Mediant 2000
3.3.5 Working with Scenarios
The Web interface allows you to create your own "menu" with up to 20 pages selected from
the menus in the Navigation tree (i.e., pertaining to the
Configuration
,
Management
, and
Status & Diagnostics
tabs). The "menu" is a set of configuration pages grouped into a
logical entity referred to as a
Scenario
. Each page in the Scenario is referred to as a
Step
.
For each Step, you can select up to 25 parameters in the page that you want available in
the Scenario. Therefore, the Scenario feature is useful in that it allows you quick-and-easy
access to commonly used configuration parameters specific to your network environment.
When you login to the Web interface, your Scenario is displayed in the Navigation tree,
thereby, facilitating your configuration.
Instead of creating a Scenario, you can also load an existing Scenario from a PC to the
device (refer to ''Loading a Scenario to the Device'' on page
39 ).
3.3.5.1 Creating a Scenario
The Web interface allows you to create one Scenario with up to 20 configuration pages, as
described in the procedure below:
¾
To create a Scenario, take these 10 steps:
1.
On the Navigation bar, click the
Scenarios
tab; a message box appears, requesting
you to confirm creation of a Scenario:
Figure 3-14: Scenario Creation Confirm Message Box
Note:
If a Scenario already exists, the Scenario Loading message box appears.
2.
Click
OK
; the Scenario mode appears in the Navigation tree as well as the menus of
the
Configuration
tab.
Note:
If a Scenario already exists and you wish to create a new one, click the
Create
Scenario
button, and then click
OK
in the subsequent message box.
3.
In the 'Scenario Name' field, enter an arbitrary name for the Scenario.
4.
On the Navigation bar, click the
Configuration
or
Management
tab to display their
respective menus in the Navigation tree.
5.
In the Navigation tree, select the required page item for the Step, and then in the page
itself, select the required parameters by selecting the check boxes corresponding to
the parameters.
6.
In the 'Step Name' field, enter a name for the Step.