AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 588 / 650

User's Manual 588 Document #: LTRT-65432
MP-11x & MP-124
44.11.5.3 Call Forwarding Parameters
The call forwarding parameters are described in the table below.
Table 44-44: Call Forwarding Parameters
Parameter Description
Web: Enable Call Forward
[EnableForward]
Enables the Call Forwarding feature.

[0] Disable

[1] Enable (Default)
For FXS interfaces, the Call Forward table (FwdInfo parameter) must
be defined to use the Call Forward service. The device uses SIP
REFER messages for call forwarding.
Notes:

To use this service, the devices at both ends must support this
option.

For the device to respond to SIP 3xx responses with a new SIP
request (forwarding the original request), set this parameter to
Enable.
Call Forwarding Table
Web: Call Forwarding Table
EMS: Analog Gateway
Provisioning > Tab: Call
Forward
[FwdInfo]
This table parameter configures call forwarding of IP-to-Tel calls (using
SIP 302 response) to other device ports or an IP destination, based on
the device's port to which the call was originally routed.
The format of this parameter is as follows:
[FwdInfo]
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime;
[\FwdInfo]
Where,

Index = Port number, where 0 denotes Port 1.
For example:

Below configuration forwards calls originally destined to Port 1 to
"1001" upon On Busy:
FwdInfo 0 = 1,1001,30;

Below configuration forwards calls originally destined to Port 2 to an
IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30;
Note: For a detailed description of this table, see Configuring Call
Forward on page 309 .
Call Forward Reminder Ring Parameters
Notes:

These parameters are applicable only to FXS interfaces.

For a description of this feature, see Call Forward Reminder Ring on page 285 .
Web/EMS: Enable NRT
Subscription
[EnableNRTSubscription]
Enables endpoint subscription for Ring reminder event notification
feature.

[0] Disable (default)

[1] Enable
Web: AS Subscribe
IPGroupID
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).