increase the audio level, use a screwdriver to turn the audio level adjustment knob clockwise. Turn the audio
level adjustment knob counter-clockwise to reduce the audio level.
7.
Adjust the volume control knob on the AWR6032U receiver to have an optimal sound quality.
(IV)
GUITAR OR INSTRUMENT SYSTEM
1. Set the antennas at an angle 45° from the floor and 90° away from each other to achieve the best RF
reception.
2. Connect the AWR6032U receiver DC input to an AC power source via the supplied AC/DC adaptor.
3. Connect the AWR6032U receiver audio output to the guitar amplifier input via the supplied audio cable or any
other appropriate cable. (Note: There are two outputs: one unbalanced output and one balanced output.)
4.
Place one 9V battery into the battery housing of the AWX6030G transmitter with the battery polarity oriented
as indicated. Connect the supplied guitar to the AWX6030G transmitter.
5.
Turn on the power of the AWR6032U receiver. The Power On LED light will be turned on.
6.
On the AWX6030G, the On/Off switch has three positions: “ON”, “STDBY” and “OFF”. When the On/Off
switch is turned to
the “STDBY” or directly to the “ON” position, the low battery LED indicator will blink once
and then stay off. If the low battery LED indicator stays on, the 9V battery needs to be replaced. When the
On/Off switch is set to the “STDBY” or “ON” position, the corresponding channel 1 RF LED light or channel 2
RF LED light on the AWR6032U receiver will be turned on. The corresponding channel 1 AF LED light or
channel 2 AF LED light will be on whenever the AWX6030G transmitter receives any audio signal while the
On/Off switch is set at the “ON” position. The audio level adjustment knob is preset at midpoint. If you need
to increase the sound level, use a screwdriver to turn the audio level adjustment knob clockwise. Turn the
audio level adjustment knob counter-clockwise to reduce the sound level.
7.
Adjust the volume control knob on the AWR6032U receiver to have an optimal sound quality.
OPERATION NOTES
1.
The AWX6030, AWX6030M, AWX6030H, or AWX6030G needs to be turned off before changing the 9V
battery.
2.
Signal dropout or unexpected noise may be caused by a low battery or by an excessive distance between the
transmitter and the receiver. If you encounter signal dropout or unexpected noise, please check the battery
first. If battery is still fresh, try to readjust the antennas on the AWR6032U receiver.
3.
Avoid placing the receiver in a corner to prevent any RF reception deterioration.
4.
Avoid placing the receiver antennas close to an obstruction or close to any metal surface.
5.
Try to place the receiver as far away from any digital equipment, including computers and some CD players,
as possible.
6.
If more than one AWM6032U wireless microphone systems are stacked together or placed in a rack, do not
let the antennas touch each other or cross each other.
7.
Before the AWM6032U is to be used in a new location, place the AWR6032U receiver at the intended location
and walk-through the area with the transmitter to locate any radio frequency blind spot, where a momentary
loss of sound or short period of noise may occur whenever the transmitter is moved to this spot.
8.
Do not drop the transmitter on the floor or strike the transmitter with any object.
9.
Always turn off the transmitter and remove the battery if the transmitter is not to be used for a period of time to
prevent the transmitter from being damaged by a leaking battery.
