CONDUCTOR
reference pre amplifier_
INSTALLATION AND OPERATION
MAIN VOLTAGE
Make sure that your home voltage is the same as the printed voltage on the lable of
the rear side of the power supply.
Please notice that you never exceed the main voltage in the prescribed value shown on
the lable of the serial number on the rear side.
If you can`t provide the amplifier with the exact shown main voltage, please use
a voltage stabilizer - particulare for the US ( 117 VAC )
and Mainland China market.
PLACEMENT AND VENTILATION
This AudioValve
CONDUCTOR
amplifier is designed to
operate at a moderately high temperature. The ideal location
is on the rigid stand or floor mounted away from direct contact with any objects,
materials or deep pile carpets which may be effected by the heat or which may interrupt
the flow of air around the amplifier.
When operating the amplifiers quite a lot of heat is generated which should be allowed to
dissipate without restriction. Make sure that no objects are placed on the top of the
amplifier. Always ensure adequate ventilations.
MAIN POWER
connection is via supplied plug-in lead. The standard IEC socket connects
the mains power at the amplifier end while a local mains plug is required at the wall end.
In the event where a "local" plug needs to be fitted to the wall end of the lead, ensure
that the plugs is wired correctly by a suitable qualified or experienced person.
Ensure the amplifier is disconnected from the main voltage before attempting
any modification of the main connection.
MAIN FUSE
The Mains fuse is fitted in the IEC Main / Line socket on the rear of the power supply.
The fuse must has the value 1,6A for 230 VAC and 3,15A for 117 VAC slow blow.
If the fuse keeps blowing up the amplifier must be checked by a professionel technican.
DO NEVER FIT A FUSE WITH HIGHER RATING.
INPUT TERMINALS
The 6 * RCA and XLR Inputs
are standard terminals for the
use of unbalanced and balanced input signals coming from the signal sources . The
CONDUCTOR uses for all XLR inputs female jackets and for the output male jackets.
The micro - controller handles the use of balanced or unbalanced signals. You have to
configure them in a
special setup
- routine for each input separately.
