Assistent 30
integrated tube amplifier__________________________________
Please switch OFF the main power while leaving the house or sleeping, the red light in front will be
go off !
Make sure that your home voltage is the same as the printed voltage on the lable of the rear side
of the power supply.
Please notice that you never exceed the main voltage in the prescribed value shown on the lable of
the serial number on the rear side.
If you can`t provide the amplifier with the exact shown main voltage, please use a voltage
stabilizer - particulare for the US or Taiwan ( 115 VAC, max. 120 V AC )
and Mainland China market with 230 V AC.
MAIN FUSE
The Mains fuse is fitted in the IEC Main / Line socket on the rear of the power supply.
The fuse must has the value 1,6A for 230 VAC and 3,6 A for 115 VAC slow blow.
If the fuse keeps blowing up the amplifier must be checked by a professionel technican.
DO NEVER FIT A FUSE WITH HIGHER RATING.
INSTALLATION AND OPERATION
PLACEMENT AND VENTILATION
This AudioValve
ASSISTENT 30
amplifier is designed to
operate at a moderately high temperature. The ideal location
is on the rigid stand or floor mounted away from direct contact with any objects, materials or deep
pile carpets which may be effected by the heat or which may interrupt the flow of air around the
amplifier.
When operating the amplifiers quite a lot of heat is generated which should be allowed to dissipate
without restriction. Make sure that no objects are placed on the top of the amplifier. Always ensure
adequate ventilations.
MAIN POWER
connection is via supplied plug-in lead. The standard IEC socket connects the mains
power at the amplifier end while a local mains plug is required at the wall end. In the event where
a "local" plug needs to be fitted to the wall end of the lead, ensure the at the plugs is wired
correctly by a suitable qualified or experienced person.
Ensure the main switch of the rear side of this amplifier is OFF before attempting any modification
of the mains connection.
MAINS FUSE
A Mains fuse is fitted within the IEC Mains / Line socket on the rear of the amplifier. A small draw
at the bottom of this socket may be removed
(after the IEC plug is removed)
by levering it out
with a flat blade screw driver. The fuse fitted should be razed at no greater than 1,6A for 230 VAC
and 3,15A for 115 VAC slow blow.
In the unusual event that this fuse should blow, you must first
establish the cause of this failure, cure the fault and then replace the fuse with one of the same
type.
DO NOT FIT A FUSE WITH HIGHER RATING.
