7
OPERATION
1.
Switch on the sound source (TV, PC, VCR, DVD player or audio component) that
the transmitter is connected to.
2.
Place the headphones On/Off switch in the On position.
3.
Before placing headphones on head, make sure the volume is not too loud and
then place the headphones on your head and adjust the volume to obtain the
desired sound level.
4.
There are 3 available channels. Press the Auto Scan button on the headphones
to search for the best reception. The corresponding indicator light will illuminate.
NOTE:
You should then be able to move freely from one room to another with no interference.
If interference does occur (interruptions in the signal), press the Auto Scan button once
to find a better reception channel.
A
For better stereo reception, stay approximately 23 feet away from the transmitter
when you press Auto Scan.
B
If it is impossible to find a satisfactory frequency, change the channel setting
(CHANNEL 3
x
2
x
1) on your transmitter, then press Auto Scan to find the
corresponding channel.
To protect the transmitter and save power, the transmitter will automatically switch off
after approximately four minutes if the signal from the audio source is too weak. If,
however, the signal returns to an acceptable level, the transmitter automatically
switches back on.
8
TECHNICAL SPECIFICATIONS
Transmission mode
: UHF stereo
Carrier frequency
: 900Mhz
Operating voltage
: Transmitter – 12V 150 mA
Receiver – 2.4 V (two rechargeable batteries, LR03/AAA size)
Frequency response
: 50 Hz – 12 KHz
Distortion
: 1%
Signal-to-noise ratio
: 72 dB
Channel separation
: 50 dB
Range
: 165 feet max.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
