Audio Trade Pro-Jet Pre Box RS, Инструкция по применению

Страница: 3 / 4

© Audio Trade GmbH · Pro-Ject Pre Box RS (from S/N D16273) · Revision 2013.10.1
3
Mains power connection
Connect the low voltage plug from the power supply to the Power 18-20V " socket before connecting the
power supply to the mains.
Remote control
1
ON/OFF
turns the unit on or back into standby
0 _
VOL
and
0
+
VOL
adjust the sound volume
CH+
CH-
VOL+ VOL-
ON/OFF
0
_
CH
and
0
+
CH
select the inputs
Front panel controls
Pre Box RS
To switch on from standby or to standby
The switch on the left hand side of the front panel turns the unit on or back into standby. The blue LED above
the stand-by switch shows that the unit is switched on.
!
After switching on, the tubes need a short time to reach the correct operating temperature. During
warm up the blue LED above the stand-by switch is blinking.
We recommend to set the volume control to 0, prior to switching on.
Input selector
After the unit is powered on, operating the switch next to the six LEDs selects the inputs. The selected input
will be shown by the corresponding LED.
Volume
Adjust the volume to the desired level, using the large knob on the front panel.