background image

Содержание ACM2150

Страница 1: ...x 871 Fortltude Valley QLD 4006 Ph 07 3852 1312 Fax 07 32521237 2U277 tlddleboriugh Road Box Hlll VIC 3128 PO Box lSi Blackburn South VIC glg0 Ph 03 98907477 Fax 03 9890 7927 WA SA TAS 7164 66 Kent Street PO Box 489 Cannlngton WA 6107 Ph 08 9356 2761 Fax 08 9356 2762 Electronlc Concepts pty Ltd 76 George Street Thebarton SA 50gl PO Box 7030 Hutt Street Adelalde SA 5000 Ph 08 82349444 Fax 08 8234 l...

Страница 2: ...put level depending on the level of the input signal from a mixer or other sigrral source The factory default setting for this control is I volt input will supply full load into 4 ohms POWef SWitCh The rocker switch located in the front centre of the panel turns AC power on to the ACM2I50 Rocking the power switch to the right to turns the AC power on When the AC power is on the CH A and CH B LED s...

Страница 3: ... Output Level VU MeteIl Two 9 segment LED VU meters are provided to give an indication of the output signal levels of each channelof the ACM2I50 from 21 to 3 dB For normal operation the LED s should oscillate in and out of the red zone If the LED s in the red zone are lit continually then the output level control or the level of the input signal to the ACM2I50 should be adjusted to reduce the oupu...

Страница 4: ... These outputs channels A B cannot be selected or wired for bridged mode mono operation DC Low Voltage Fuse Receptacles Access the DC fuses by turning the caps half a turn counte clockwise with a screwdriver The value of the fuses is 5 Amps slow blow Please ensure in t tn AC power switch is i the off position and that the mains power cord is disconnected before attempting to check o pla any of the...

Отзывы: