We recommend that you use Alkaline batteries and that you avoid using NiCad if possible.
Remove the battery cover by unscrew and pull the cover off and insert the battery into the battery
compartment and screw the battery compartment back into place.
To change the cannel of operation, unscrew the battery cover and pull the cover off
Locate the cannel selector rotary switches. Set the channel to the corresponding channel as set on
receiver. Replace cover over the rotary switches.
Turn the transmitter switch to the on position. Confirm that the receiver is receiving RF. Speak directory
into the microphone and confirm audio is passing through the receiver
You are now set to use the system.
PART4. USING THE ATW-R600 RECEIVER
The ATW -R600 receiver operates with AC adapter supplied . Connect AC adapter DC output plug to
receiver DC in jack and AC cable to adapter AC plug. Plug the other end of AC cable into an AC outlet.
Confirm that the LED comes on. Check the cannel setting to confirm that they correspond to the
settings of the transmitter
Connect the unbalanced audio output to your mixer or PA system. Adjust the receiver and mixer of PA
system volume setting to the desired level. Speak into the microphone and listen to the audio out at the
speaker. If satisfied with the audio quality, you can use the system.
