3
18
19
20
22
21
23
7
8
9
10
11
6
12
13
15
14
16
17
3
4
5
Main Features
Figure 1
1. POWER DIAL
Controls power to the unit.
2. DUAL START/STOP BUTTONS
Engages and disengages the motor/platter.
3. PLATTER SPEED BUTTONS
Select 33 or 45 RPM platter speed. (Note: 78 RPM is selected by
pressing both the 33 and 45 buttons simultaneously; both buttons
should be illuminated.)
4. PLATTER
Cast aluminum platter mounts directly to center spindle/motor shaft.
5. STROBE DOTS (on platter edge)
Operate in conjunction with stroboscopic light located under the
power dial (1) to provide visual indication of accurate platter speeds.
6. CENTER SPINDLE
Precision-machined platter mount on motor shaft.
7. REMOVABLE STYLUS TARGET LIGHT
Provides illumination directed at the stylus position for easier cueing
in low light. Easily plugs into jack on top of turntable deck.
8. START CONTROL KNOB
Rotate the start control knob to increase or decrease platter start
time between 0.2 – 6.0 seconds. (Minimum setting is the quickest
start; maximum setting is the slowest start to reach selected speed.)
9. BRAKE CONTROL KNOB
Rotate the brake control knob to increase or decrease platter brake
time between 0.2 – 6.0 seconds. (Minimum setting is the quickest
stop; maximum setting is slowest.)
10. REVERSE CONTROL KNOB
Controls platter’s rotational direction.
11. SELECT SPEED RANGE
/- 10 or 20% speed range. (Note: +/-50% is selected by
pressing both the 10 and 20 buttons simultaneously.)
12. HEADSHELL
Standard, interchangeable stereo cartridge headshell.
13. HEADSHELL LOCKING RING
Rotate counter-clockwise (to the left) to draw the inserted headshell
firmly into its seated, locked position. Rotate the ring a full turn to
the right to permit removal of the headshell.
14. QUARTZ BUTTON
This button is used to turn the pitch function on and off. When
the Quartz is activated the platter will hold the RPMs at 0% pitch,
regardless of the pitch slider position and speed range control settings.
15. PITCH ADJUST SLIDE CONTROL
Use in conjunction with pitch button to vary the platter’s rotational
speed. In the center detent position quartz lock is active.
16. TONE ARM ASSEMBLY HEIGHT ADJUST
Raises and lowers the entire tone arm assembly to allow the tone
arm to remain parallel to the record surface.
17. TONE ARM LIFT
Elevates tone arm above record surface.
18. TONE ARM REST WITH LOCKING CLAMP
Locking clamp secures tone arm during transport.
19. TONE ARM LIFT CONTROL LEVER (“Cueing Lever”)
Controls action of tone arm lift. (Note: Lift mechanism is
hydraulically damped to slow tone arm descent.)
20. ANTI-SKATE CONTROL
Applies a small outward force to the tone arm, counteracting the
tendency of the tone arm to move inward toward the center of
the record.
21. TONE ARM ASSEMBLY HEIGHT LOCK
(Hidden under counterweight in drawing.)
Locks the tone arm height setting. (Always fully unlock before
attempting to make a height adjustment.)
22. COUNTERWEIGHT
Balances the tone arm and provides adjustment for proper
downward tracking force on the stylus.
23. 45-RPM ADAPTER (Shown in receptacle)
Adapt 7" records with large center holes to fixed center spindle.
