WARNING!
DISCONNECT THE BATTERY
LEADS BEFORE INSTALLATION,
MAINTENANCE OR REMOVAL.
12V
WARNING!
USE ONLY IN VEHICLES WITH A
12 VOLT NEGATIVE GROUND
PLUGGING IN OF THE RTC-CARD
INST
ALLA
TION
PLUGGING IN OF THE RTC CABLE
ADJUSTMEN
ADJUSTMENT:
from 0 to -20dB
WARNING! CAUTION:
IN CASE OF TROUBLE IMMEDIATELY DISCONTINUE
USE. Failure to comply may cause injury or damage the
product. For repair please contact an authorized MOSCONI
dealer.
DO NOT DISASSEMBLE OR MODIFY THE PRODUCT: This
action may result in accidents, fire or electric shock. Any
alteration or modification to the product immediately voids
any expressed or implied warranty.
THE INSTALLATION AND CONNECTION OF THE
PRODUCT SHOULD BE PERFORMED BY QUALIFIED
PERSONNEL. The installation and connection of the product
require specific technical background and experience. For
safety reasons, always contact an authorized dealer to install
the product in a correct way.
DO NOT INSTALL IN AREAS PARTICULARY HUMID OR
DUSTY. Avoid installing the product in areas excessively
humid or dusty. Presence of humidity or dust inside the
product can cause malfunction.
WHILE DRILLING HOLES, DO NOT DAMAGE TUBING AND
CABLES. While drilling holes in your vehicle during
installation, pay close attention to avoid damaging, blocking
or contact with: tubing, the fuel lines, the fuel tank and
electrical cables. Failure to follow these precautions will pose
a fire hazard and damages.
USE THIS PRODUCT EXCLUSIVELY IN VEHICLES WITH
12V POWER. Using the product with electrical power other
than 12V may cause fires, electric shock or other accidents.
DISCONNECT THE NEGATIVE (GROUND) BATTERY
LEAD BEFORE CONNECTING THE PRODUCT. Failure to
do so may cause electric shock or other damage and injury
due to short circuit.
ENSURE PROPER CONNECTIONS. To avoid fire hazard
and damage to the product, use cables of proper gauge and
pay close attention to the polarity of the connections.
AVOID TANGLING THE CABLES TO VEHICLE PARTS.
Make proper connections by following the instructions so that
the cables do not interfere with proper vehicle operation.
Cables that tangle with steering components, gear
lever,
brake pedals, etc may be dangerous.
LAY OUT THE CABLES TO ENSURE THAT THEY ARE NOT
BENT OR COMPRESSED BY SHARP METAL EDGES. To
avoid damaging or bending the cables, lay out the cables far
from moving parts (such as the seat rails) and from sharp or
pointy vehicle parts. If the cables are to pass through a hole in
a metal sheet, use a rubber ring to ensure that the cable
insulation won't be cut by any sharp edge.
USE THE CORRECT ACCESSORY PARTS AND FOLLOW
THE INSTALLATION INSTRUCTIONS. Be sure to use only
specified accessory parts. Using other components may
damage the product or result in improper installation.
Components may not be connected securely and cause
malfunction or danger.
DO NOT OPERATE THE PRODUCT IN WAYS THAT MAY
DISTRACT YOUR ATTENTION FROM DRIVING. Any
operation that requires continued attention must be done
when the vehicle is at full stop. Always stop the vehicle in a
safe area when performing such operations. Failure to do so
may cause accidents.
MAINTAIN THE VOLUME AT LEVELS THAT ALLOW
EXTERNAL NOISES TO BE AUDIBLE WHILE DRIVING.
Excessive volume levels, capable of blocking the sound of
emergency vehicles, rail crossings, etc, may be dangerous
and cause accidents. Furthermore, listening to audio at high
volume inside a vehicle may cause damage to your hearing.
IMPORTANT: CAREFULLY READ THIS MANUAL TO FAMILIARIZE YOURSELF WITH
ALL THE CONTROLS AND FUNCTIONS OF THIS PRODUCT. FOLLOW ALL NOTICES
TO ENSURE THE SAFETY OF THOSE INSTALLINGAND USING THE PRODUCT.
