background image

Limited Warranty

Audio  Research  Corporation  products  are  covered  by  a 
3-Year  Limited  Warranty  or  a  90-Day  Limited  Warranty
(vacuum  tubes).  This  Limited  Warranty  initiates  from  the
date of purchase, and is limited to the original purchaser, or
in  the  case  of  demonstration  equipment,  limited  to  the 
balance  of  warranty  remaining  after  original  shipment  to
the retailer or importer.

In  the  United  States,  the  specific  terms,  conditions  and
remedies for fulfillment of this Limited Warranty are listed
on the warranty card accompanying the product in its ship-
ping  carton,  or  may  be  obtained  from  the  authorized 
retailer  or  from  the  Audio  Research  Customer  Service 
Department.  Outside  the  United  States,  the  authorized 
importing retailer or distributor has accepted the responsi-
bility  for  warranty  of  Audio  Research  products  sold  by
them.  The  specific  terms  and  remedies  for  fulfillment  of
the  Limited  Warranty  may  vary  from  country  to  country.
Warranty  service  should  normally  be  obtained  from  the 
importing  retailer  or  distributor  from  whom  the  product
was purchased.

In the unlikely event that technical service beyond the abil-
ity  of  the  importer  is  required,  Audio  Research  will  fulfill
the  terms  and  conditions  of  the  Limited  Warranty.  Such
product must be returned at the purchaser's expense to the
Audio  Research  factory,  along  with  a  photocopy  of  the 
dated  purchase  receipt  for  the  product,  a  written  descrip-
tion  of  the  problem(s)  encountered,  and  any  information
necessary for return shipment. The cost of return shipment
is the responsibility of the purchaser.

Specifications

POWER OUTPUT

: 220 watts per channel into 8 ohms from

20Hz to 20kHz. 380 watts per channel into 4 ohms.

POWER BANDWIDTH:

(-3dB points)  2Hz to 80kHz.

FREQUENCY RESPONSE: 

(-3dB points at 1 watt) 

0.5Hz to 200kHz.

INPUT SENSITIVITY: 

4.0V RMS BAL for 

rated output. (20.8 dB Bal gain into 8 ohms.)

INPUT IMPEDANCE:

300K ohms Balanced, 150k ohms SE.

OUTPUT POLARITY

: Non-inverting. Balanced input pin 2+ 

(IEC-268).

OUTPUT REGULATION:

Approximately 0.07dB 8 ohm load

to open circuit (Damping factor approximately130).

OVERALL NEGATIVE FEEDBACK: 

None.

SLEW  RATE:

20 volts/microsecond.

RISE TIME:

1.6 microseconds.

HUM  & NOISE:

Less than 0.1mV RMS – 112dB below rated

output (IHF weighted, input shorted). 

POWER SUPPLY CAPACITANCE:

200,000 uF.

POWER REQUIREMENTS:

105-125VAC 60Hz (210-250VAC

50Hz) 750 watts at rated output (220 WPC 8 ohms) 1200
watts max (380 WPC 4 ohms) 250 watts idle.

TUBES REQUIRED: 

2 – 6H30 Driver, 2 – 6922 Voltage amp.

DIMENSIONS : 

19" (48.3 cm) W x 8.75" (22.2 cm) H x 19.5"

(49.5 cm) D. Handles extend 1.5" (3.8 cm) forward.

WEIGHT:

58.9 lbs. (26.8 kg) Net; 73.8 lbs. ( 33.6 kg ) Shipping.

Specifications subject  to change without notice.

©2007 Audio Research Corporation.

5

Model HD220

Содержание HD220









Отзывы: