background image

Limited Warranty

Audio  Research  Corporation  products  are  covered  by  a  3-
Year  Limited  Warranty,  or  a  90-Day  Limited  Warranty 
(vacuum  tubes).  This  Limited  Warranty  initiates  from  the
date of purchase, and is limited to the original purchaser, or
in  the  case  of  demonstration  equipment,  limited  to  the 
balance  of  warranty  remaining  after  original  shipment 
to the retailer or importer.

In  the  United  States,  the  specific  terms,  conditions  and
remedies  for  fulfillment  of  this  Limited  Warranty  are 
listed  on  the  warranty  card  accompanying  the  product  in
its shipping carton, or may be obtained from the authorized
retailer  or  from  the  Audio  Research  Customer  Service 
Department.  Outside  the  United  States,  the  authorized 
importing retailer or distributor has accepted the responsi-
bility  for  warranty  of  Audio  Research  products  sold  by
them.  The  specific  terms  and  remedies  for  fulfillment  of
the  Limited  Warranty  may  vary  from  country  to  country.
Warranty  service  should  normally  be  obtained  from  the 
importing  retailer  or  distributor  from  whom  the  product
was purchased.

In  the  unlikely  event  that  technical  service  beyond  the 
ability  of  the  importer  is  required,  Audio  Research  will 
fulfill  the  terms  and  conditions  of  the  Limited  Warranty.
Such product must be returned at the purchaser's expense
to  the  Audio  Research  factory,  along  with  a  photocopy  of
the  dated  purchase  receipt  for  the  product,  a  written 
description  of  the  problem(s)  encountered,  and  any  infor-
mation  necessary  for  return  shipment.  The  cost  of  return
shipment is the responsibility of the purchaser.

Specifications

POWER OUTPUT

: 450 watts into 8 ohms (550 watts 

per channel into 4 ohms), both channels driven, 1% THD. 
(700 watts into 4 ohms, one channel driven)

POWER BANDWIDTH:

(-3dB Points) 5Hz to 45 kHz into 

8 ohms.

FREQUENCY RESPONSE: 

(-3dB points at 1W) 5Hz to 

45 kHz

INPUT SENSITIVITY: 

2.9V RMS for rated output (26dB Gain)

single-ended or balanced.

INPUT IMPEDANCE:

150K ohms single-ended, 300K ohms

balanced differential.

OUPUT POLARITY:

Non-inverting from single-ended inputs. 

Balanced pin 2+ (IEC-268).

OUTPUT REGULATION:

0.02dB 8 ohm load to open circuit

(Damping factor 440).

OUTPUT CURRENT: 

35 amps peak at protective shutdown.

SLEW  RATE:

5 volts/microsecond. (20% maximum duty

cycle).

RISE TIME:

8.0 microseconds.

HUM & NOISE:

300 microvolts RMS (105dB below rated 

output IHF A-weighted).

POWER SUPPLY CAPACITANCE:

217,000 uF total.

POWER REQUIREMENTS:

100-125VAC 60Hz 

(200-250VAC 50Hz) 950 watts at rated output (400WPC 
8 ohms), 1300 watts at 550WPC 4 ohms, 1300 watts 
maximum, 55 watts idle.

DIMENSIONS:

19" (48 cm) W (standard rack panel) x 7" 

(17.8 cm) H x 18.4" (46.7 cm) D (front panel back). Handles 
extend 1.5" (3.8 cm) forward of the 

3

/

8

" thick front panel. 

Output connectors extend 1.5" (3.8 cm) behind rear panel.

WEIGHT:

55.8 lbs. (25.4 kg) Net; 71 lbs. (32.3 kg) Shipping.

Specifications  subject to change without notice.

©2009  Audio Research Corporation.

Model DS450

4

Содержание DS450








Отзывы: