background image

   

8   

Limited Warranty 

Audio  Research  Corporation  products 
are  covered  by  a  3-Year  Limited 
Warranty,  or  a  90-Day  Limited  Warranty 
(vacuum  tubes).  This  Limited  Warranty 
initiates from the date of purchase, and 
is  limited  to  the  original  purchaser,  or  in 
the  case  of  demonstration  equipment, 
limited  to  the  balance  of  warranty

 

remaining  after  original  shipment  to  the 
retailer or

 

importer.

 

In  the  United  States,  the  specific  terms, 
conditions and remedies for fulfillment of 
this  Limited  Warranty  are  listed  on  the 
warranty  card  accompanying  the 
product in its shipping carton, or may be 
obtained  from  the  authorized  retailer  or 
from  the  Audio  Research  Customer 
Service  Department.  Outside  the  United 
States,  the  authorized  importing  retailer 
or  distributor  has  accepted  the 
responsibility  for  warranty  of  Audio 
Research products sold by them. 
The  specific  terms  and  remedies  for 
fulfillment  of  the  Limited  Warranty  may 
vary  from  country  to  country.  Warranty 
service  should  normally  be  obtained 
from  the  importing  retailer  or  distributor 
from whom the product was purchased. 
In  the  unlikely  event  that  technical 
service  beyond  the  ability  of  the 
importer is required, Audio Research will 
fulfill  the  terms  and  conditions  of  the 
Limited Warranty. Such product must be 
returned  at  the  purchaser's  expense  to 
the  Audio  Research  factory,  along  with 
a  photocopy  of  the  dated  purchase 
receipt  for  the  product,  a  written 
description 

of 

the 

problem(s) 

encountered,  and  any  information 
necessary  for  return  shipment.  The  cost 
of  return  shipment  is  the  responsibility  of 
the purchaser. 
 

Specifications 

POWER  OUTPUT: 

450W into 8 ohms (650W into 

4 ohms), 1% THD. 

POWER  BANDWIDTH: 

(-3dB  points)  5Hz  to 

45kHz into 8 ohms. 

FREQUENCY  RESPONSE: 

(-3dB  points  at  1W) 

5Hz to 45kHz into 8 ohms. 

INPUT  SENSITIVITY: 

2.9V RMS for rated output 

(26dB Gain) single-ended or balanced. 

INPUT  IMPEDANCE: 

150K  ohms  single-ended, 

300K ohms balanced differential. 

OUPUT  POLARITY: 

Non-inverting  from  single-

ended input.  Balanced pin 2+ (IEC-268). 

OUTPUT  REGULATION: 

0.02dB  8  ohms  loaded 

to open circuit (Damping factor 440). 

OUTPUT  CURRENT: 

~

35  amps  peak  at 

protective shutdown. 

SLEW  RATE: 

5  volts/microsecond.  (20% 

maximum duty cycle). 

RISE TIME: 

8.0 microseconds. 

HUM  &  NOISE: 

<

300  microvolts  RMS  (105dB 

below rated output IHF A-weighted). 

POWER  SUPPLY  CAPACITANCE: 

176,800  uF 

total 684 Joules. 

POWER REQUIREMENTS: 

100-125VAC 60Hz 

(200-250VAC 50Hz) 550 watts at rated output 

(450W into8 ohms), 700 watts at 650W into 
4 ohms, 700 watts maximum, 55 watts idle. 

DIMENSIONS: 

19"  (48  cm)  W  (standard  rack 

panel) x 5.25" (13.3 cm) H x 14.25" (36.2 cm) 
D  (front  back  panel).  Optional  handles 
extend  1.5"  (3.3  cm)  forward  of  the 

3

/

8

thick  front  panel.  Output  connectors 
extend 1.5" behind rear panel. 

WEIGHT: 

37.2 lbs. (16.9 kg) Net; 43.3 lbs. (19.7 

kg) Shipping. 

 
 

Specifications subject to change without notice. 
©2011 Audio Research Corporation. 

 

 
 

 

 
 

 

3900 Annapolis Lane North 

Plymouth, MN  55447 

763.577.9700 

www.audioresearch.com 

Содержание Definition DS450M









Отзывы: