6
audio pro
2.2 To Speakers output terminal
(High level)
Connect speaker wires from the speaker terminals of
your amplifier to the HIGH LEVEL INPUT of the
subwoofer. Carefully check the polarity of the wires
(+ to + and - to -). Connect both Left and Right channels.
The satellite speakers are connected to SPEAKER OUT-
PUT on the
subwoofer. Again, carefully check the polar-
ity (+ to + etc).
In this installation, the satellite speakers HIPASS cross-
over frequency is automatically set to 100 Hz. If you
want the speakers to perform full frequency range,
connect them to the normal amplifiers Speaker Output.
INSTRUCTIONS
Congratulations to your choise of Audio Pro SUB FOCUS subwoofer and to a new sound
experience.
Audio Pro
SUB FOCUS
is a unique product built with advanced technique. It is very easy to
handle and install.
SUB FOCUS
is equipped with the unique Audio Pro
ace-bass
technicue that in
combination with the built-in 400 watts amplifier, the 10" long throw woofer and the extremely solid
cabinet offers a natural and deep bass reproduction at sound levels you never thought existed.
The
Audio Pro SUB FOCUS
offers extraordinary performance and lots of possibilities. In order
to get the most out of your new subwoofer, we recommend you to spend time and carefully read
these instructions before you connect and start up your system.
What is ace-bass ?
Normally, speaker design is bound to follow the laws of physics. The consequence will be, to get
deep bass, the speakerbox must be very large. With the ace-bass technique we can "change" the
laws of physics in the way that the driver believes it is placed in a much larger speaker box.
Furthermore, the ace-bass technology improves the driver performance. With the ace-bass
technique, we can design smaller subwoofers with deeper and cleaner bass.
2. INSTALLATION
There are different methods to connect your
subwoofer
to a HiFi / Home Theater system. In the following text
we explain 2 different ways.
NOTE! Do not connect
the mains cord until all other installation is
completed.
2.1 To an amplifier / pre-amplifier with
Subwoofer-out terminal.
Connect the enclosed RCA cord from your amplifiers
subwoofer-out terminal to LINE IN on the subwoofer. Use
the
e
nclosed Y-adaptor to divide the signal to both inputs.
The audio signal is passing through the cords from the
subwoofer-out terminal to the built-in amplifier. By using
the LOWPASS control, the upper frequnency of the
subwoofer can be variably selected from 50Hz - 100
Hz.
Note:
Connect the satellite speakers to the amplifiers
speaker terminals.
1. UNPACKING
Carefully unpack the Audio Pro
SUB FOCUS
and check for any damages. If possible, keep the cartonbox if future
transportation is needed. Locate the enclosed RCA cord and Y-adaptor.
You should immediately contact your dealer if the
subwoofer
is damaged .
