BAKSIDA
| REAR VIEW | RÜCKSEITE | ACHTERAANZICHT
PARA
| PAIR | KOPPELN | KOPPELEN
STANDBY LÄGE
| STANDBY MODE | STANDBY MODUS | STANDBY MODUS
Standby läge
Standby mode
Standby-Modus
Standby-Modus
Blinkar
Flashes
Blinken
Knippert
Inställningar
Settings
Einstellungen
Instellingen
1.
2.
5-20s
20min › Zzz
Alltid tillgänglig
Always selectable
Immer wählbar
Altijd selecteerbaar
ON/STBY
AUDIO PRO T4
KONTROLLER
| CONTROLS | SCHALTTAFEL | BEDIENINGSELEMENTEN
På/Av
On/Off
Ein/Aus
Aan/uit
Para Bluetooth
Pair Bluetooth
Koppeln Bluetooth
Koppelen via Bluetooth
Välj ljudkälla
Select source
Quelle auswählen
Bron selecteren
Volymkontroll
Volume control
Lautstärkeregelung
Volumeregeling
ADD
ON T4
EN:
User
manual
SE:
An
vändarmanual
DE:
Schnells
tar
t-
Anleitung
NL:
Gebr
uik
er
shandleiding
FCC
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS:
1 - THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
2 - THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
MODEL: T5. FCC ID: 2AGNC - T5
FCC WARNING
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.This device
complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncon-
trolled environment.Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
IC
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) This device may not cause interference,
and (2) This device must accept any inter-
ference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appar-
eils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suiv-
antes:
(1) l’appareil ne doit pas produire de brouil-
lage, et
(2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compro-
mettre le fonctionnement.
