EN-650W-01-x Installation Manual
Document # 540246, Rev IR, 05/2002
Page 4 of 10
2.0 Application
2.1 Introduction
The EN-650W-01-x is mounted as a single unit. It contains a crossover
network that separates low range (below 175 Hz) audio input. Level
control is a single turn potentiometer to adjust input level. Power input is
115 VAC / 400 Hz; output power is 200 W
RMS
. This unit comes with
integrated mounting hardware and a ported enclosure.
2.2
Block Diagram -Typical Application
3.0 Installation
3.1
Prior to Installation
The EN-650W-01-x speaker is a simple module to install. Prior to
installation the following items should be considered:
3.1.1 During the design and layout of the aircraft cabin, careful
consideration of the location of this and all other audio/video
modules is necessary. Some of the items to consider include:
•
Space
•
Proximity to other devices (i.e. source equipment)
•
Available power supply
•
Length of cable runs
•
Environmental conditions (temperature, humidity, etc.)
•
Location of other aircraft systems (i.e. oxygen delivery)
•
Access for service repair (if applicable)
•
Convenience for user interface (if applicable)
3.1.2 The EN-650W-01-x speaker shall
be installed to conform to the
standards designated by the customer, installing agency, and
existing conditions as to the unit location and type of installation.
