Audio international DVD-01x-40x, Руководство по установке изделия

Страница: 9 / 17

AUDIO INTERNATIONAL, INC. 2/98
9
Document #540066, Rev. IR, Model No.: DVD-01x-x, DVD-01x-40x
2.9 Post Installation Test
Verify that all audio and video outputs are available to the appropriate distribution
system(s). Load a DVD disc into the video player. Use the DVD front-panel
controls or the hand-held remote control unit to select PLAY. Check for a picture
on the appropriate monitor(s) and verify that the DVD audio can be heard through
the speaker and/or headphone systems.
3.0 Operation
3.1 The video disc player has several front panel controls. To play, insert the chosen
DVD video disc into the unit and press the PLAY button. The video disc picture
will be displayed on the selected monitor screen(s). If the disc inserted is an
audio CD only, then verify that audio is playing properly as required.
3.2 When the DVD reaches the end of the disc, the DVD will automatically stop
playback. Once the DVD has stopped, the OPEN/CLOSE button on the front
panel must be pressed to unload the disc.
3.3 If power is interrupted (>500 ms) or power drops below 18VDC while a CD is
playing in the video disc player, the player will shut down. The CD tray must be
opened and then closed to restart the player.
3.4 Refer to the Operation Guide for the specific model number for further operating
instructions.
4.0 Troubleshooting
Problem Possible Cause Solution
No sound/No picture Unit is improperly installed
No video material in source unit.
Audio system not turned
powered or active Verify 28 VDC power and video
input is present
Insert video material in source
unit
Verify audio system is in active
mode.
Poor video quality Poor video disc quality. Replace video material, clean
disc, make sure disc is not
scratched or damaged.