25
Rev.2.10
●
When mounting on a wall
When installing the receiver and cables to a removable wall, follow the instructions shown below.
1) The mounting bracket is fixed to a wall with a screwdriver using a provided screw.
Note:
• Fix this unit firmly with specified torque with a tool such as a torque driver.
2) Connect the necessary cables to the receiver.
Connect the cables in accordance with the directions in the Connections section on page 18.
3) Install the receiver.
A receiver is hooked on the hook of the mounting bracket.
（
Four places
）
Open the screw cover.
A receiver is fixed to mounting bracket with a screw driver using a provided screw.
Close the screw cover.
Note:
• Fix this unit firmly with specified torque with a tool such as a torque driver.
4) After installation, check that all parts are firmly installed.
Check visually for loose parts and connections.
IMPORTANT:
• Procure 4 screws (M4) to secure the mounting bracket (accessory) to a ceiling or wall according to the material of the installation
area. In this case, wood screws and nails should not be used. For mounting a receiver on a concrete wall, use an anchor bolt (M4) or
an AY plug bolt (M4) for securing. (Recommended tightening torque: 1.6 N
・
m {1.18 lbf
・
ft})
• Mount the mounting bracket (accessory) in consideration of the camera angle in accordance with the instructions
• Required pull-out capacity of a single screw/bolt is 196 N {44 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced.
• Install the mounting bracket (locally procured) in the foundation area of the architecture or where sufficient strength is assured.
• To prevent the mounting strength from becoming lower, do not use wooden screws to secure the mounting bracket (locally
procured).
Applicable mounting bracket Recommended screw
Number of screw Minimum pull-out strength (per 1 pc.)
Mounting bracket (accessory) M4
4 pcs.
196 N {44 lbf}