Audio Design ESX Direction DC500, Руководство пользователя

Страница: 11 / 12

DISCHARGING PROCESS
If the capacitor will be uninstalled you need to discharge it completely. To dis-
charge the capacitor, remove the wire at the ”+” terminal of the capacitor. Keep
the ground terminal “-” connected. Then bridge the ”-”pole and ”+”pole of the
capacitor with the supplied light bulb.
The discharging process could last some minutes.
It is recommended to use a gripper during this procedure, because the light
bulb may get very hot.
If the light bulb stops flashing, the discharging process is accomplished.
Never discharge the capacitor without the supplied light bulb.
Never discharge the capacitor with bypassing the terminals (short circuit).
The capacitor may get damaged or explode.
VOLTMETER ADJUSTMENT
The adjustment is already done by the factory, but can be redone if necessary.
By using additional capacitors, various indicated values could be occurred. This
can be adjusted by the potentiometer.
Follow these instructions:
1.) Measure the actual operating voltage on the ”+” and ”–”pole of the capacitor
by using an appropriate multimeter.
2.) Remove the acrylic-cover of the capacitor and adjust the value with the
potentiometer (little blue box) by using a appropriate screwdriver to the same
value, you have measured before.
3.) Ensure while removing the cover, not to short the terminals.
4.) Or ask your car audio retailer.
Ground Terminal
Battery Terminal
Light bulb
+