15
D I S C H A R G I N G P R O C E S S
If the capacior will be de-installated you need to discharge it completely. To
discharge the capacitor, remove the wire at the ”+” terminal of the capacitor.
Keep the ground terminal “-” connected. Then bridgeover the ”-”pole and
”+”pole of the capacitor with the supplied resistor.
The discharging process could last some minutes.
It is recommended to use a gripper during this procedure, because the resistor
may get very hot.
The display is flashing and shows ”0.00” during the discharging when the
voltage drops below 10 Volts. If the light bulb stops flashing, the discharging
process is accomplished.
CAUTION: Never discharge the capacitor without the supplied resistor.
Never discharge the capacitor with bypassing the terminals (short
circuit).The capacitor may get damaged or explode.
V O L T M E T E R A D J U S T M E N T
The adjustment is already done by the factory, but can be redone if necessary.
By using additional capacitors, various indicated values could be occured. This
can be adjusted by the potentiometer.
Follow these instructions:
1.) Measure the actual operating voltage on the ”+” und ”–”pole of the capacitor
by using an appropriate multimeter.
2.) Remove the acrylic-cover of the capacitor and adjust the value with the
potetiometer (little blue box) by using a appropriate screwdriver to the same
value, you have measured before.
3.) Ensure while removing the cover, not to short the terminals.
4.) Or assign your car audio retailer.
Resistor
10.00
Battery
Terminal
Ground
Terminal
