PRE-OUT
PRE-OUT
1
2
DESCRIPTIONS AND FUNCTIONS
1. AC VOLTAGE SELECTOR
- Check to make sure that the AC Voltage Selector switch is set to the proper
voltage for your area (120V/60Hz for the North America area) before plugging in the AC power cord
to the AC power outlet.
CAUTION:
Unplug the
power cord from the
power outlet before resetting the
voltage
selector switch.
3. ~115V/60Hz ~230V/50Hz AC Power Input Terminal
5. KEY CONTROLLER
- This KEY CONTROLLER 3.5mm input jack is to be connected to some special
equipment, such as a key control microphone.
. MIC INSERT
- These are the TRS ¼” microphone effect inserts. The tip of the insert is used as the audio
signal output (to the sound effect equipment), the ring of the insert is used as the audio signal input (from
the sound effect equipment), and the sleeve is used as the ground. The MIC1 is the microphone effect
insert for the MIC1 input. The MIC2/3 is the microphone effect insert for the MIC2 and MIC3 inputs.
. VIDEO INPUT
- There are two video inputs, VCD and DVD.
8. VIDEO OUT
- There are two independent video output jacks (each with its own driver).
9. MIC AUDIO OUTPUT
- This audio output comprises the microphone audio signal only.
AC
AC
AC
2. FUSE
- Please turn off the AC power and unplug the AC power cord before replacing the fuse. (ONLY
)
6
7
replacing with the same type and rating of new fuse. When the AC VOLTAGE SELECTOR is set to either
115V or 230V, the new fuse should have the rating of
T1AL/250V
.
4. PRE OUT
- The pre-amplifier audio output (PRE-OUT) can be connected to an external power amplifier
if needed.
-
6
1
2
3
4
5
6
7
8
9
10 11 12 13
14
VCD
T1A/250V
10. REC AUDIO OUTPUT
- This audio output is for the recording purpose and comprises a fixed
predetermined audio level.
11. LINE AUDIO OUTPUT
- This is a line audio output with the audio level controllable by the
microphone and music volume controls.
12. INPUT A (VCD/CD)
13. INPUT B (DVD)
14. EFFECT LOOP
- The EFFECT LOOP allows the AKJ7004 user to add any sound effecter, such as an
equalizer, as a part of the music loop in the AKJ7004 unit. If an external sound effect is not used,
check to make sure that two U-shaped connectors are connected from the OUT jacks to the IN jacks.
The top U-shaped connector is to be connected from the white OUT jack to the white IN jack.
The bottom U-shaped connector is to be connected from the red OUT jack to the red IN jack. If a
sound effecter is to be placed in between the OUT jacks and the IN jacks, the U-shaped connectors
need to be removed from the unit and make sure that these two U-shaped connectors are taped to the
bottom of the unit for future use. The OUT jacks are to be connected to the input ports of the sound
effecter while the IN jacks are to be connected to the output ports of the sound effecter.