Audi A8 2010, Руководство по обслуживанию

Страница: 77 / 142

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure:
– Loosen sealing cap -4- of oil filter using socket (32 mm) . This
causes a valve to open.
– Wait a few minutes to allow engine oil to drain from filter hous‐
ing into crankcase.
– Completely remove sealing cap. Make sure that no engine oil
drips onto engine.
– Pull oil filter element -2- and seal -3- out of sealing cap -4-.
– Clean sealing surfaces of sealing cap -4-.
– Lightly lubricate new seal -3- with engine oil and fit it.
– Fit new oil filter element -2- in sealing cap.
– Screw sealing cap -4- into oil filter housing -1- and tighten it to
specified torque using socket (32 mm) (see table of tightening
torques for installation ⇒ page 72 ).
Continue installation in reverse sequence.
Note
There is more than one version of the oil filter for the 6-cylinder
3.0 ltr. TFSI petrol engine ⇒ page 71 .
3.43.4 8-cyl. petrol engine 4.0 ltr. TFSI
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331- , measuring range 6 to 50 Nm
♦ Or: torque wrench - VAS 6583- , measuring range 3 to 60 Nm
♦ Or: torque wrench - VAS 5820- , measuring range 20 to 100
Nm
Table of tightening torques for installation:
Component/fastener [Nm]
Sealing cap 25
Requirements:
• Engine oil drained.
Procedure:
– Loosen sealing cap using socket (32 mm) and remove it.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance
73