Audi A8 2010, Руководство по обслуживанию

Страница: 35 / 142

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure:
– Check by hand that battery terminal clamps are securely seat‐
ed. If necessary tighten nuts -2- and -4- to specified torque
(see table of tightening torques for installation ⇒ page 30 ).
– Check by hand that battery is securely installed. If necessary
tighten securing bolts -arrows- on retainer plate to specified
torque (see table of tightening torques for installation
⇒ page 30 ).
Install in reverse sequence.
3.7.2 A8 hybrid
DANGER!
Risk of fatal injury if high-voltage components are damaged.
♦ Observe warnings for high-voltage system:
♦ Handling high-voltage wires
⇒ page 11 .
♦ For work in the vicinity of high-voltage components
⇒ page 10 .
WARNING
Risk of injury due to loose battery clamp on positive terminal.
♦ Disconnect battery clamp from negative terminal and then
tighten battery clamp on positive terminal.
Special tools and workshop equipment required
♦ Torque wrench - VAS 6583- , measuring range 3 to 60 Nm
Table of tightening torques for installation:
Component/fastener [Nm]
Battery terminal clamps (battery -
A-)
4
Battery terminal clamps (second
battery -A1-)
4
Bolts for retainer plate on battery
base
24
Battery -A- and second battery -A1- are located under the luggage
compartment floor.
Requirements:
• Ignition switched off during test.
Removal steps:
– Remove cover for high-voltage battery unit ⇒ Rep. gr. 70 ;
Removing and installing luggage compartment floor; Remov‐
ing and installing high-voltage battery unit .
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance
31