Audeze THE KING, Руководство пользователя, Страница: 9 / 16

Real-Time Metering
The front panel LED SPL meters are calibrated to show actual SPLs when
used with the LCD-4. The 75-segment LEDs display true SPLs from 90dB to
120dB. The last red LED segment warns of SPLs greater than 120dB. You
should NEVER see this red LED if you value your hearing!
1. Quarter-Inch TRS Headphone Connectors - Two output connectors allows
sharing your music or comparing two headphones.
2. Overload Protection – A red LED indicates that an overload condition has
occurred; the output relay will disconnect the headphone as long as the
problem persists.
3. Low Impedance (Short) – A yellow LED indicates that the connected
headphone impedance is lower than 10 ohms; the output relay will not
activate with this load.
4. LED SPL Meter - Two rows of green LEDs show momentary SPL levels on
the LCD-4; peak level follows current level with a slight hold. The scale is
held in place with magnets and is removable.
5. Volume Control
Connecting the King Headphone Amplifier
Connect the left and right source component output cables to the left
and right RCA or XLR analog inputs on the back of The King. XLR inputs
are provided for balanced devices but The King is internally wired for
single-ended operation and only the positive XLR input is active. The
negative XLR input is terminated to ground through a 22k ohm resistor.
Connect the AC power cord, and then your headphone to the standard
quarter-inch stereo output connector on the front panel. Be sure to keep
the volume low on first listen.
T H E K I N G
M I N M A X
1 2 3 5 4
FRONT PANEL