3
Instructions
Assembling and connecting
The RGA10 consists of three parts, two radials and a middle section, which should
be assembled together. The two radials are bended in a circular shape. To attach the
radials to the middle section, the two bolts on the top side and the two nuts on the
bottom side of the middle section need to be removed.
The next step is to place the two radials in their correct position by placing them into
the sockets, place the bolts and washers back into their position, and tighten the
screws to fix them.
It can be attached to a pole with a diameter of 30-50mm, by means of the mounting
clip in the center position of the RGA10
.
To connect a coaxial cable to the RGA10, the coaxial cable should be stripped as
shown in the figure below. Then slide the waterproof boot over the cable outer jacket,
and assemble the F-connector to the cable end. Afterwards, the connector should be
attached to the connection terminal on the bottom side of the antenna.
Содержание RGA10
Страница 1: ...RGA10 Installation Manual www audac eu ...
