AUDAC ISP40, Руководство пользователя

Страница: 11 / 20

11
Rear Panel overview
Rear panel description
AC Power inlet with fuse:
The mains power supply (100-240V AC - 50/60 Hz) has to be applied to this AC power
inlet. The connection is made by an IEC C14 power connector and is fitted with a fuse. When
replacing the fuse, make sure that the value of the replacement fuse matches the value of
the original fuse. (T0.5AL/250V)
RS232 Connection:
The RS232 connection can be used to control the system through any external hardware
such as home and industrial automation systems. The pinout and communication settings
are described in an earlier chapter of this user manual. The complete RS232 command
instruction set and configuration information can be downloaded from the AUDAC website.
USB (Update) Connection:
The USB (Update) connection can be used for system firmware updates and/or for connection
of the RF remote control (RMT40) receiver.
Balanced stereo line output:
The balanced stereo line output is implemented using two 3-pin terminal block connectors.
The audio output available on this connector allows it to be fed to any amplifier or pre-amplifier
Ethernet RJ45 Connector:
The Ethernet connection implemented using an RJ45 type connectors. This Ethernet
connection works as the audio stream input of the ISP40. Hereby it shall get connected to
any LAN network with internet access for reaching the database and audio streaming servers.
For more information about the Ethernet configuration of this device, check ‘Chapter 4: User
interface & Configuration’ and ‘Chapter 4: IP Basics’ of this user manual.