AUDAC ATEO2S, Руководство пользователя и инструкция по установке

Страница: 7 / 10

7
Step 2: Make the connections
After the mounting bracket is attached, the connections shall be made. The ATEO2S
only allows connection in low impedance mode (8 Ohm for ATEO2S and 16 Ohm for
ATEO2SD) and therefore a terminal block connector is provided. The wires coming
from the amplifier should be connected to the spring clamp terminal block connector.
The polarity is indicated through the color coding of the wires. The red wire is the +
terminal while the black wire is the COM terminal. Make sure the polarity is always
correct throughout the entire system.
Once connected, the ceiling cover can be slided and clicked in place, nicely covering
the screws and connections. Mind the direction of the fixation clips at the inner side of
the cover, to make sure they nicely get into place when pressed onto the bracket.
Mind the polarity markings when wiring the loudspeaker cables.