AUBER INSTRUMENTS
WWW.AUBERINS.COM
Instruction Manual
2014.02
P3/3
5. Error Message and trouble shooting
5.1 Display EEEE
This is an input error message. The possible reasons are, the sensor is not
connected correctly; or the sensor is defective. Open the connector to see if
there is any short or loose soldering point inside. Terminal 2 and 3 should be
shorted together. Resistance between terminal 1 and 2 should be around
110ohms at room temperature.
5.2 No heating
The OUT LED should be synchronized with heater light. If there is no heat
when it is supposed to, check OUT first. If it is not lit, the controller parameter
setting is wrong. If it is on, then the problem is with the SSR or heater.
4. Temperature setting
6. Detailed parameter settings
Detailed parameter settings of this controller can be found in manual
for PID controller SYL-2362 . You can find the instruction manual on
our website or following link: http://auberins.com/images/Manual/
SYL-2362%20instruction%201.6.pdf. You do
NOT
need to read the
SYL-2362 manual unless:
you feel the control result is not satisfactory and want to retune
the P. I and D parameters.
you want to use this controller for difference applications other
than sous vide cooking, such as cooling control, manual power
adjusting, limit control, on/off control.
you want to use the alarm indicators.
There are two ways to set the target temperature.
a. During the normal operation mode, press up key Or Down key once
to switch the display from PV to set value. The display will start to blink.
Press Up key or Down key again to increase or decrease the SV. When
finished, wait 8
seconds and the settings will take effect automatically
(the display will stop blinking).
b. PrEss set key once. Use Shift, Up And Down keys to enter code
0001. Press set key to confirm, then the display would be SV (
Su
).
Press set key again to display the SV setting. Use Shift, Up And Down
Keys to enter the new SV value and press Set to confirm. Press down
key to change the display to END. Then, press set to exit. You can also
ignore the steps after confirmation of SV. The controller will returns to
normal operation mode automatically if no key is pressed for 1 minute.
This method is easier for large temperature change.
Warranty
Auber Instruments warrants this controller to be free from defects
in material and workmanship for a period of one (1) year from the
date of the original purchase when utilized for normal use, subject
to the following conditions, exclusions and exceptions.
Please return it if your appliance fails to operate properly while in
use under normal household conditions within the warranty
period
.
If the appliance is found by Auber Instruments to be defective in
material or workmanship, Auber Instruments will repair or replace
it free of charge. A dated proof of purchase may be required.
The liability of Auber Instruments is limited solely to the cost of the
repair or replacement of the unit at our discretion. This warranty
does not cover normal wear of parts and does not apply to any
unit that has been tampered with or used for commercial
purposes. This limited warranty does not cover damage caused
by misuse, abuse, negligent handling or damage due to faulty
packaging or mishandling in transit. This warranty does not cover
damage or defects caused by or resulting from damages from
shipping or repairs, service or alterations to the product or any of
its parts which have been performed by a repairperson or facility
not authorized by Auber Instruments.
This warranty is available to the original purchaser of the unit and
excludes all other legal and/or conventional warranties. The
responsibility of Auber Instruments, if any, is limited to the specific
obligations expressly assumed by it under the terms of the limited
warranty. In no event is Auber Instruments liable for incidental or
consequential damages of any nature whatsoever. Some states/
provinces do not permit the exclusion or limitation of incidental or
consequential damages and therefore the above may not apply to
you.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state or province to
province.
*Important: Carefully pack item(s) to avoid damage in shipping. Be
sure to include proof of purchase date and to attach tag to item
before packing with your name, complete address and phone
number with a note giving purchase information, model number
and what you believe is the problem with item. We recommend
you insure the package (as damage in shipping is not covered by
your warranty). Mark the outside of your package ATTENTION
CUSTOMER SERVICE . We are constantly striving to improve
our products and therefore the specifications contained herein are
subject to change without notice.
Auber Instruments Inc.
5755 North Point Parkway, Suite 99,
Alpharetta, GA 30022
www.auberins.com
e-mail: [email protected] Tel: 770-569-8420
