AUBER INSTRUMENTS
WWW.AUBERINS.COM
2020.04
P2/2
3.4.1
Standard Mode
When the controller is powered up in standard mode or switched to standard
mode, the top display will show “
std
” briefly.
This controller has been programmed for 100 Watt hot runner coil. The set
temperature has been set to 300
°
F. If you want to change the set temperature,
please follow the steps below:
1) Press down the knob briefly. The decimal point in the lower right corner of
the bottom display will start flashing.
2) Turn the control knob to adjust the set temperature. Turn it clockwise to
increase the value; counter-clockwise to decrease the value. Use fast rotation
action for big adjustment, use slow rotation action for single digit adjustment.
3) Press down the knob again to confirm the new set temperature. The
controller will also exit the editing mode if the knob was untouched for 10
seconds.
3.4.2
Boost Mode
In a boost mode, the user can quickly cycle between two set temperatures, a
lower standby temperature and a higher boost temperature, by simply pressing
down the control knob. There is no need to turn the knob back and forth to
adjust for the desired set temperature.
To switch from the standby temperature to the boost temperature, simply press
down the control knob. The lower display will show the new set temperature,
which is the boost temperature. To switch back to the standby temperature,
press down the knob again.
There are 3 boost modes available, named as “
b-1
”, “
b-2
”, and “
b-3
”. A user
can adjust and save customized standby temperature and boost temperature
for each mode. By default, the standby temperature is 300°F and the boost
temperature is 550°F for all three boost modes.
When the controller is powered up in a boost mode or switched to a boost
mode, the top display will show the name of the boost mode briefly and then
show the coil temperature. The bottom display will show the standby
temperature.
More detailed explanation of the boost mode and the related parameters can
be found in the RDK-300B Supplementary Manual.
3.4.3
Switching Between Standard Mode and Boost Mode
To change the operating mode, turn the control knob in any direction for at
least a half turn (180°) in one action to bring up the mode-selecting menu. The
top window will show “
MOD
” and the bottom window will show the name of
the current mode. Turn the knob slowly in either direction to browse the options
in the menu and press down the control knob to confirm your selection. The
flashing dot in the lower right corner indicates the item is in editing and has not
been saved yet.
3.5
Advanced Parameter Settings
Please see the RDK-300B Supplementary Manual for more information about
parameters.
(End)
Auber Instruments Inc.
5755 North Point Parkway, Suite 99,
Alpharetta, GA 30022
www.auberins.com
E-mail: [email protected] Tel: 770-569-8420
Copyright 2007-2020, Auber Instruments All Rights Reserved.
No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written
consent of Auber Instruments. Auber Instruments retains the exclusive rights to all information
included in this document.
