WUHAN AU3TECH TRADING CO., LTD
M
CC37
2
1
H
U
se
r’s
Q
uick
S
et
up
V1
.0
2
18
SC1000 software supports photoelectric switch /mechanical switch, and it can choose
open/close logic. Please set the limit of each axis correctly, otherwise, it may not be working
properly.
Note: Users should choose the same limit switch type with the same logic to avoid the
logical difference between X axis and Y axis.
Users may manually trigger limits/origin to see if the lights on MCC mother board can
response accordingly.
Please make sure all limits are working properly before we move to next step.
According to machine’s construction to configure the maximum trip of XY axis. After the
cutting head successfully moving back to the origin point, please check the soft limits on
software. And SC1000 will control the trip of each axis. Once the cutting head moves over
the soft limits, SC1000 will alarm.
3
、
Pulse equivalent configuration.
Users must accurately setup the parameters of pulse equivalent, or it can result in moving
speed error and precision error. The definition of pulse equivalent: the number of pulses
which can make the cutting machine travels 1mm.
e.g. when X Axis servo driver subdivide in 10000(the number of pules which can make the
motor rotates 1 circle) , the motor of X axis rotates 1 circle, the cutting machine can step
forward 10mm, then the pulse equivalent is 10000/10=1000
If the pulse equivalent is not integer, SC1000 supports keeping the last 4 digits after dot.
4
、
Back to origin point parameters configuration
Software supports going back origin twice. User can configure the origin point signal.
SC1000 supports servo motor Z phrase signal/limits/origin signal as the adapting signal of
the origin point.
