ATX ucrypt q2q, Быстрый старт, Страница: 8 / 36

QUICK START GUIDE – READ ME FIRST
2-2 MDU Solutions
®
– UCrypt
®
QAM to QAM – Quick Start Guide
2.6 Pair the CableCARD™ with its Host
You will need to pair each CableCARD module with its host, that is, the Host Slot receptacle on the UCrypt device. If this
CableCARD is not a permanent CableCARD to be installed in this unit, pairing will need to be done again with the exact
permanent CableCARD and host slot.
The process of pairing is required for security so the CableCARD may not be moved from the host that it is originally paired
with and plugged in somewhere else. If it is moved, it will require the pairing operation to be done again with the new host and
it will not decrypt any services until that is done.
The pairing information will be obtained from the Management Interface after you log in and will need to be passed to your
Billing System Administrator who will setup an account and enter the pairing information.
Refer to
“Quick Start Guide – READ ME FIRST” on page 2-1 for more details about the pairing process.
2.7 Optionally Import an Existing Configuration File
UCrypt supports mass deployment with an importable/exportable configuration file. If you have a previously exported
configuration file to import see “Quick Start Guide – READ ME FIRST” on page 2-1.
If you have no file to import skip to Step 2.1 below.
2.8 Select Programs for Decryption
After you have paired available CableCARD modules with the host receptacle slots, the UCrypt device will receive a Channel
Map by reading the Cable System VCT (Virtual Channel Table) and display available programs in a window. You should
now select channels for decryption to test CableCARD module validation and authorization. After each installed CableCARD
module is verified to be working with at least one program, continue selecting programs that will be needed for the final
output lineup. Encrypted programs may be selected for decryption and programs that are in the clear may also be selected to
passthrough to the output.
Refer to
“Quick Start Guide – READ ME FIRST” on page 2-1
2.9 Review or Change CableCARD™ Configuration
After having selected programs for decryption, you may need to change settings or remove a program.
Refer to
“Quick Start Guide – READ ME FIRST” on page 2-1 for details.
2.10 Configure Output QAM Carriers
You need to specify the QAM output frequencies and Constellation size.
Refer to
“Quick Start Guide – READ ME FIRST” on page 2-1 for details.
2.11 Assign Programs to Output QAM Carriers
Finally, the programs selected for decryption or passthrough need to be assigned to output QAM carriers.
Refer to
“Quick Start Guide – READ ME FIRST” on page 2-1 for details.
That’s it, you’re done
If you followed all the directions, you should have programs on the QAM output channels that you configured.
Use an appropriate Digital TV to view programs that are in the clear.
Use an appropriate Pro:Idiom
®
compatible TV or STB with built-in Pro:Idiom to view Pro:Idiom encrypted programs.
Download the full Installation & Operation Manual from the ATX website (atxnetworks.com) in the Resources & Support
section, User Documents sub-section for more details than are presented here. Click the Help tab to download it to your
Management Computer.
CHAPTER 2: