MODEL:
ATX FAN 100-12v
Page 2.
(V)
3. CONNECT WIRING
3-1. Follow all local electrical and safety codes,
ANSI/NFPA70.
3-2. NEVER place a switch where it can be reached
from a tub or shower.
3-3. Connect wires as shown in wiring diagrams
below and at the bottom right.
DIMENSIONS
10
3/4
"
10
3/4
"
4" DUCT
1" 5
3/4
"
8
1/4
"
SPECIFICATIONS
Model No.
Voltage
Frequency
(Hz)
Power
@ 0.1SP
(W)
Air Flow
@ 0.1SP
(CFM)
Weight
(lb.)
USING HANGER BAR
1-3. Sliding hanger bars available to allow for your
specific positioning of housing anywhere between joists
and span up to
24’’.
1-4. Insert hanger bars into the channels on housing.
Make sure tabs face
‘‘up’’
shown.
3-5. 18 AWG is the smallest conductor that shall be
used for branch-circuit wiring.
4. TEST RUN & GRILLE ATTACHMENT
4-1. When the power on, check for abnormal vibration
or sound.
4-2. Insert the mounting springs into the slots and
mount the grille to the fan unit.
ATX FAN
100-12v
12
N/A
10
100
5.6
Note: Design and specifications subject to change without notice.
1-5. Extend hanger bars to the width of the joists.
Hold fan in place with the hanger bars tabs wrapping
around the bottom of joist.
1-6. Fasten hanger bars to joists with nails or screws
through holes near nails.
1-7. Secure hanger bars together with screws.
2. DUCT CONNECTION
2-1. Insert the duct into the duct connector and tape
all ductworks connection to make them secure and air
tight.
2-2. Install the duct with a gradient 1°~2° to the
outside.
Inside Outside
5. OPERATION
5-1. Turn on the power switch to operate ON or OFF,
and LED indicator is green.
6. MAINTENANCE
WARNING:
Disconnect power source before working on unit.
Routine maintenance must be done every year.
CAUTION:
1.
Never use gasoline, benzene, thinner or any other
such chemicals for cleaning the ventilating fan.
2.
Do not allow water to enter motor.
3.
Do not soak resin parts in water over 140°F (60°C).
CLEANING
：
1.
Pull down the spring to remove grille.
2.
Wash and clean grille. (Use non-abrasive kitchen
Duct Connector
Body
Tape
Duct
Gradient
1°~2°
detergent, wipe dry with new cloth.)
3.
Using a cloth dampened with non-abrasive
kitchen detergent, remove dust and dirt from
ventilating fan. Wipe dry with new cloth.
4.
Replace grille.
Ceiling
Slots
Grille
Spring
Screw
Joist
Joist
Screw 4×25
Joist
Screw 4×25
Joist
Hanger Bar
Channel
5
3/4
"
Grille
