AtVideo HDHS243, Инструкция по эксплуатации, Страница: 9 / 22

Optional Camera Height Setting
Figure-2
Figure-3
[ft] [cm]
1. The Height strip camera has the capability to be set in the housing at 5ft or
5.5ft above the floor.
The default setting of the camera is set to 5.5ft.
If the lower setting is desired the following housing change must be
completed.
* Remove housing from gimbal
* Note the position of the hole in the housing base for cable throughput
The cable hole is at the center of the mounting bracket
* Remove four Allen flat head screws along each side of the housing and
separate the front cover with the camera from the housing base.
Allen flat head screw
* From to to change the camera position. (See Figure-2)
* Replace the front cover with the camera to the housing base after
o
turning the cover 180 f r om original position.
Replace the three Allen head screws along each side of the housing
and continue the installation
2. Camera lens position can be adjusted up and down 5 degrees.
3. Two height marker strips are provided, one marked in feet
and one marked in centimeters. Use the appropriate one.
(See Figure-3)
o
5
o
5
1
2
1 2
9