ATV IPVD2RWI, Руководство пользователя

Страница: 13 / 88

•
Connecting the Power
Connect the power of 12VDC or 24VAC for the network camera. Connect the positive
(+) pole to the + position and the negative (-) pole to the - position for the DC power.
– Be careful not to reverse the polarity when connecting the power cable.
– A router featuring PoE (Power over Ethernet) can also be used to supply power to
the camera.
– The heater will only operate properly with the power source of 24VAC.
– For the power specifications, refer to the Appendix, Product Specification.
•
Connecting Service Monitor Port
Service monitor output port (J8) is located on the board of the dome camera, and is
used for an easy OSD setup.
– ID & IP assignment
To make changes in the OSD menu, please use the OSD controller provided
optionally with your camera purchase. You can set Camera Title and IP Address.
1. Connect the OSD Controller to the Service Monitor port of the network cam-
era.
2. Connect Service Monitor and the Video Output port of the OSD Controller.
3. Press the SET button to access main Menu.
4. Change Camera ID, and IP Address. You can change the Name or Title and
IP address of the camera. Using the
↑↓←→
buttons on the controller, you can
change the parameters.
5. Select SAVE or CANCEL to exit the Main Menu.
Video Output is also used for an easy zoom and focus control when installing lens.
Video Output is restricted to 704x480(576) resolution.
13