2.2 Connection
•
Connectin
g to the RJ-45
45 cable to the network port of the network dome camera. Generally a
over cable is used for directly connection to PC, while a direct cable is used for connection
es to signal the dome camera to react on events. Mechanical or
d/or alarm output to the G (Ground) connector.
devices
to
ec
•
t is used for an easy zoom and focus
on the board) to On position to output the video
signal. Video Output is restricted to VGA(640x480)
resolution.
Caution:
ecting the Power
Connect the power of DC12V 330mA for the network camera. Connect the po) pole to the
d IP assignment
camera is first connected
th
1.
mera / device to the network and power up.
Connect a standard RJ-
cross-
to a hub.
•
Connecting Alarms
AI(Alarm In) :
You can use external devic
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G(Ground) :
Connect the ground side of the alarm input an
AO(Alarm Out) :
such as buzzers or lights. Connect the device
tors.
Video Outpu
The dome camera can activate external
the AO (Alarm Out) and G (Ground) conn
Connecting Video Output
control when installing lens. Set Video Switch (SW2
Connect your Video cable unit to J5 on the board.
After lens installation, you must set Video Switch to Off position to provide the best
performance of the Network Camera.
• Conn
‘+’ position and the negative(-) pole to the ‘-‘ position.
2.3 Network Connection an
The Network Camera supports the operation through the network. When a
to e network it has no IP address. So, it is necessary to allocate an IP address to the device with the
“Smart Manager” utility on the CD.
Connect the Network Ca
14
