unD3IO
User Manual
Attero Tech LLC 2018
Page 10
614-00017 Rev 05_a
Once the required software is installed, click on the unIFY Control Panel icon in the programs list under Attero Tech.
This will start the application.
Figure 8 - Device Configuration window
3.3 – Selecting a Network Adapter
In order to connect to a device the application needs to know what network adapter it should use to contact devices.
Clicking on the networked PC icon
will show a list of all possible adapters.
*Note:
Only network adapters that are deemed as being compatible with Dante will be shown in the list.
3.4 – Connecting to a Device
A few seconds after selecting the adapter, the device list should start to populate with detected devices. The detected
devices are listed by their device name. Select the device to be configured from the drop down list and then click the
“Connect” button. The application will then attempt to establish a connection with the device. If successful, the status
bar will show “Connected” and the controls will become active and their values will update to show the current state of
the device including channel names (shown for each input and output in a small grey window just below the main
settings).
*Note:
The label below each set of channel controls show that channels name as displayed in Dante Controller. The
channel name cannot currently be set from within the unIFY application. To change the channel names, use Dante
Controller.
This connected device is now treated as the active device and any changes to the controls will be sent to this device
alone.