AT7016
User Manual
2
1.
SAFETY PRECAUTION
The AT7016 oscilloscope is easy to operate and highly reliable. It is an ideal instrument for research,
production, education, and development. It is a compact and portable oscilloscope with a frequency
bandwidth of 10MHz and sensitivity of 5mV/DIV-5V/DIV. Supplied as standard, with a switchable X10:
X1 probe which extends the sensitivity up to 50V/div. The horizontal timebase is 0.1S/DIV to 0.1
µ
S/DIV.
The instrument is designed and tested in accordance with EN publication 61010, CAT II, Pollution
degree II and Overvoltage 600V. The instrument has been tested in accordance to the following EC
Directives (EMC) :
a. EN50082
b. EN55011
c. EN610000-3-2
d. EN61000-3-3
The instrument complies with the requirements of the European Council Directive 89/336/EEC (EMC
Directive) and 73/23/EEC (Low Voltage Directive). To ensure that the instrument is used safely, follow all
safety and operating instructions in this manual. If the instrument is not used as described in this manual,
the safety features might be impaired.
WARNING
Non compliance with the warnings and/or the instructions for use may damage the
instrument and/or its components or injure the operator.
Take extreme care under the following conditions when using the instrument:
For your own safety and that of the instrument, you must follow the procedures described in this
instruction manual and especially read all the notes proceeded by the symbol
carefully
.
Do not use this instrument in a location where there is explosive gas in the vicinity. The use of this
instrument in a location where there is explosive gas could result in explosion.
If there is any smoke, abnormal odor, or abnormal sound coming from this instrument, immediately
switch off the power and disconnect the power cord. Continuous using of this instrument under
these conditions could result in electrical shock or fire. After disconnecting the power cord, contact
the service offices for repair. Repair by the user is dangerous and should be strictly avoided.
Take care not to allow water to get into this instrument. The use of this instrument in a wet state
could result in electrical shock or fire. If water or other foreign matter has penetrated this instrument,
first switch the power off, remove the power cord and call for repair.
