ATTACK SQ-1, Руководство по установке

Страница: 3 / 12

Squirrel Rev C 3
1.
Choose where to install, what size, and
what color LEDs are to be used. Next, choose
the desired SQ-1 blink MODE (See Blink Mode
Section page 5).
NOTE – The blink MODE indicates
where to plug each LED into the SQ-1
controller.
2.
Drill Holes for LED Holders. Be careful
to not drill the hole too large. NOTE - You can
purchase a hand drill from your local RC hobby
store. Follow carefully all safety instructions
provided with the drill.
3.
Snap LED Holders into Holes.
4.
Insert LEDs into LED Holders. It is
recommended to apply a pliable glue, such as
Zap Goo or Shoe Goo, liberally making sure the
glue contacts the body, the LED and LED wires.
The glue should strengthen the wires and help
the LEDs last longer.
NOTE - The proper glue may be
purchased from an RC hobby store.
LED INSTALLATION
5.
Attach SQ-1 Controller to vehicle using it’s
double back adhesive or using the breakaway
mounting tabs.
6.
Connect LEDs to the SQ-1 Controller
NOTE: Connect each LED depending on the
desired blink MODE. See Blink Mode Section on
page 5.