In case of
“
EMERGENCY ON
” you need to select the position
of this number (specifies in what order it will be dialed)
-
Use ▲ or ▼ to select the position
- Press
to confirm
In case you want to overwrite an existing position, you will
have to
confirm “
OVERWRITE?
” by pressing
STORING EMERGENCY MESSAGE
•
Press
PRO
•
Press ▲ 4 x to select “
RECORD MESSAGE
”
•
Press and
hold
,
wait for beep,
“
VOICE
” icon is
flashing
•
After the beep, say the message
•
Release the
button to finish the recording
•
Press
PB/D
to leave the menu
The maximum length of recording is
‘20’ seconds
TEST EMERGENCY MESSAGE
•
Press
PRO
•
Press ▲ 5 x to select “
CHECK MESSAGE
”
•
Press
to listen to the recorded message
•
Press
PB/D
to leave the menu
TEST SYSTEM OPERATION
First call your chosen emergency contacts to inform them
they are on your emergency contact list. Instruct your
contacts how to accept, extend and/or end the call with the
proper procedure. After they have been informed to press
0 to accept, 1 5 to extend and 1 9 to terminate, press the
Pendant button or the SOS button to perform an actual test.
Now you can proceed with other features (i.e., contact name
recording, etc.)
Page 3
TROUBLESHOOTING GUIDE
System is always calling 911 when I press the button
even when 911 is not a contact.
When the panic button is pressed longer than 3 seconds the device
will bypass the emergency contacts and go directly to 911. (see
page 25)
Alarm Does Not Sound When Button Pressed:
Step 1:
Verify that the pendant is paired with the Personal
Assistance Voice Dialer 4. (See page 16 for pairing instructions)
Step 2:
Make sure the Pendant’s battery is good. (light comes on
and stays on when the button is pressed and held for 20 seconds, or
does it dim? If the light dims replace the pendant battery)
Step 3:
Replace pendant battery if necessary, with (1) 12v DC
#21/23 battery.
The phone is not calling out when the button is
pressed:
Step 1:
Check the phone cord.
Step 2:
Lift receiver to check that you have a dial
tone – pick up handset and dial number manually
Step 3:
Confirm numbers are programmed correctly (local or Long
Distance) -Confirm Emergency On / Off option is correct for each
emergency contact number.
Step 4:
Verify if the phone line is ‘Tone’ that the Dial Mode setting
is set to ‘Tone’. If the phone line is ‘Pulse’ the Dial Mode setting
should be set to ‘Pulse’.
Unit Keeps calling all contacts after the call has
ended:
Step 1:
The emergency contact that answers and accepts the call
will need to press 1 9 to terminate the call sequence.
Page 26
